They have a wide flat bottom for low draft, a narrow bow that is flat, often mistaken for the transom , which instead is pointed. This is another bonus for owning one these boats. Also, drift boats hold up pretty well, even boats that have some road rash or a few dents float just fine. We affectionately call them bow-puppies;. You must log in or sign up to reply here. Slipstream may be the only drift boat builder east of the Mississippi -- a significant savings on shipping for eastern US fisherman. Speaking of seats, make sure they are adjustable and allow for sliding or moving the seats to balance the boat.
Outdoor News: Drift boating for steelhead
Drift Boat Bottom Coating Options
I've floated it on the Bitterroot a few times which can be too skinny for a hard boat much of the season. I wish I knew what the result would have been if it was coated with LineX. The cutting scraps generated from cutting out the silhouette of the bottom must be used on the last foot or two under the transom area behind the main sheet. The anchor weighs 55 , the boat about and I've drug it from here to kingdom come, through rocks and over rock and everything in between. The earliest drift boats were made out of various types of wood. I plan on bolting it to the bottom and then putting in 4" of flotation foam and then another inside floor.
HOW IT’S DONE – Gravitas Drift Boats
The damage shown is severe and beyond patching. Vince was not kidding. Front pedestal pieces on the mold. The skid shoe is attached to the bottom of the boat with stainless steel screws. Unfortunately, the colder weather and my day job have slowed us down a little. This bottom coating proved superior and outperformed the commonly used product in everyway possible.
Since , ClackaCraft has built fiberglass drift boats of the highest quality. The pipe will be used to route the anchor rope through the pedestal and underneath the floor. Frequently running a motor, or want to split passengers between the front and back? Flip over the bottom and repeat on the other side. Ultra high molecular weight plastic UHMW was designed as an abrasion resistant surface for use in the lumber industry. I wish I knew what the result would have been if it was coated with LineX. Next the front and rear panels of the dry boxes along with part of the frame were installed.
15 days ago